14How To Set Origin Mark Stabilization; 15How To Inscribe Origin Marks - Furuno FAR-2218-BB Operator's Manual

1.42.14 How to set origin mark stabilization
You can mark any prominent target or a point of particular interest using the origin
mark feature. Twenty origin marks may be entered: 10 standard origin marks (with
number) and one each of the 10 symbol origin marks. The marks may be geographi-
cally fixed (ground stabilized) or sea stabilized. To display the origin marks, heading
signal and own ship position data are required.
Origin marks can be geographically fixed (ground stabilized) or moving (sea stabi-
lized).
1. Select the [MARK] box at the bottom-left of the screen then right-click to open the
[RADAR MAP] context menu.
2. Select [2 ORIGIN MARK STAB].
3. Select [GND] or [SEA] as appropriate, then press the ENTER MARK key.
4. Close the menu.
1.42.15 How to inscribe origin marks
You can inscribe origin marks anywhere inside the operational display area, however,
marks cannot be inscribed in the same location as a menu box.
Depending on the setting for [4 MARK POSITION] the method to inscribe a mark is
slightly different.
Note: The following procedures assume that [3 MARK TYPE] is set to either [ORIGIN
MARK(No.)] or [ORIGIN MARK(SYM)]. For how to set the mark type, see
section 1.42.1.
Where [4 MARK POSITION] is set to [CURSOR]
1. Place the cursor inside the [MARK] box. The [MARK] box is now highlighted.
2. Spin the scrollwheel to select the appropriate origin mark, then left-click. The cur-
sor moves inside the operational display area.
3. Place the cursor on the location (inside the operational display area) you wish to
inscribe the origin mark, then left-click to anchor the origin mark.
4. Repeat steps 1 to 3 for multiple origin mark inscription, or right-click to complete
the procedure.
Where [4 MARK POSITION] is set to [OWN SHIP]
1. Place the cursor inside the [MARK] box. The [MARK] box is now highlighted.
2. Spin the scrollwheel to select the appropriate origin mark, then left-click. The se-
lected mark is inscribed at the OS position.
3. Repeat steps 1 to 2 for multiple origin mark inscription, or right-click to complete
the procedure.
1. OPERATIONAL OVERVIEW
1-77