How To Adjust Symbol Brilliance; How To Display/Remove Target Data; Tt Pop Up Information - Furuno FAR-2218-BB Operator's Manual

3. TARGET TRACKING (TT)
3.9.3

How to adjust symbol brilliance

1. Place the cursor on the [PLTx] ("x" indicates the current color palette in use) indi-
cation inside the [BRILL] box, then right-click. The [BRILL] menu appears.
2. Select [0 NEXT] to show the next
menu page.
3. Select [7 TT SYMBOLS]. The settings
are highlighted and can now be ad-
justed.
4. Spin the scrollwheel to select the de-
sired brilliance, then left-click to apply
the setting.
5. Close the menu.
3.9.4 How to set the symbol color
1. Open the menu.
2. Select [5 TT•AIS].
3. Select [4 TT•AIS SYMBOL].
4. Select [2 TT•AIS SYMBOL COLOR]. The settings
can now be adjusted.
5. Select the appropriate color, then left-click.
6. Close the menu.
3.10

How to Display/Remove Target Data

The TT mode provides the full functionality of TT as required by the IMO Resolution
A.823(19) and IEC 62288, including display of range, bearing, course, speed, CPA
and TCPA of all tracked targets.
The target bearing is shown in relative bearing in the HEAD UP mode and true bearing
in the COURSE UP, NORTH UP and True Motion modes, with the suffix "R" (Relative)
or "T" (True).
The target speed and course are shown as speed over the ground or speed through
the water depending on speed source.
3.10.1

TT pop up information

The TT pop-up shows abbreviated TT data (target no., COG, SOG, CPA and TCPA)
for the selected TT. Simply put the cursor on the TT symbol to show the pop-up. The
popup can be enabled or disabled with [7 TT POP-UP INFO] in the [TT•AIS SYMBOL]
menu.
3-10
Spin the
scrollwheel
to adjust the
brilliance.