How To Erase Individual Waypoints - Furuno FAR-2218-BB Operator's Manual

5. VIDEO PLOTTER OPERATION
How to enter/edit waypoints from the menu
Note: Waypoints which are part of a route that is currently in use cannot be edited.
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [2 WPT SET].
4. Select [2 WPT NO. SELECT].
5. Spin the scrollwheel, or use the control unit numbered
keys, to select a waypoint number, then left-click.
6. To edit or input a waypoint name, select [3 WPT
NAME], then left-click. The software keyboard ap-
pears. Referring to section 1.5.2, name the waypoint.
To skip naming the waypoint, go to step 7.
7. Select [4 WPT L/L]. The latitude and longitude set-
tings can now be adjusted.
8. Input the latitude and longitude with the number keys, or spin the scrollwheel to
select a digit, then left-click to move to the next digit.
9. Close the menu.
5.5.3

How to erase individual waypoints

There are two methods to erase individual waypoints: cursor selection or from the
menu.
How to erase a waypoint by cursor selection
1. Place the cursor inside the operational display area, then right-click.
2. Select [MARK DELETE]. The mark delete function is activated and the cursor is
highlighted when inside the operational display area.
3. Select the waypoint you wish to delete, then left-click.
4. Right-click inside the operational display area to deactivate the mark delete func-
tion.
How to erase a waypoint from the menu
1. Open the menu.
2. Select [8 NAVLINE•WPT].
3. Select [6 WPT SET].
4. Select [2 WPT NO. SELECT]. Then select the waypoint to erase.
5. Select [5 CLEAR DATA].
6. Select [YES] or [NO] as appropriate, then left-click.
7. Close the menu.
5-14