Furuno FAR-2218-BB Operator's Manual page 219

(Continued from previous page)
1 2
9 RADAR MAP DISPLAY
Next page
2 GRID (OFF, ON)
3 NAV TOOLS 2 PI LINES
3 EBL • VRM •
CURSOR SET*
* 1 : Shown for
B-type only.
* 2 : Shown for
IMO/A/R
types only.
3
* : Shown for
A/B-types
3 EBL • VRM •
only.
CURSOR SET*
4 RANGE RINGS (OFF, ON)
4 ALERTS 2 WATCH ALERT (OFF, 6min, 10min, 12min, 15min, 20min)
3 ALERT VOLUME (OFF*
4 ANCHOR WATCH (OFF, ON; 0.00NM to 9.99NM)
5 TARGET ALARM
5 TT•AIS 2 ACQUISITION
ZONE
3 TRIAL
MANEUVER
2
1
(Continued on next page)
2 MARK (OFF, ON)
3 BUOY (OFF, ON)
4 DANGER (OFF, ON)
5 COAST LINE (OFF, ON)
6 CONTOUR LINE (OFF, ON)
7 NAV LINE (OFF, ON)
8 PROHIBITED AREA (OFF, ON)
2 PI LINE BEARING (REL, TRUE)*
3 SET MAXIMUM PI LINES (1, 2, 3, 6)
4 PI LINE MODE (PARALLEL, PERPENDIC)
5 RESET PI LINES
6 TRUNC RANGE1 (OFF, ON; 0.000NM to 24.000NM)
7 TRUNC RANGE2 (OFF, ON; 0.000NM to 24.000NM)
2 EBL1 (REL, TRUE)
1
3 EBL2 (REL, TRUE)
4 VRM1 (NM, km, SM, kyd)
5 VRM2 (NM, km, SM, kyd)
6 EBL OFFSET BASE (STAB GND, STAB HDG,
7 VRM TTG (OFF, 1, 2, 1and2)
8 VRM OFFSET (OFF, LINK EBL)
9 CURSOR
2 EBL OFFSET BASE (STAB GND, STAB HDG,
2
3 VRM TTG (OFF, 1, 2, 1and2)
4 VRM OFFSET (OFF, LINK EBL)
5 EBL•CURSOR BEARING (REL, TRUE)
6 CURSOR L/L ALIGN (OFF, ON)
3
, LOW, MID, HIGH)
2 ALR1 MODE (IN, OUT)
3 ALR2 MODE (IN, OUT)
4 LEVEL (1, 2, 3, 4)
2 AZ/ALR SELECT (ACQUISITION ZONE, TARGET ALARM ZONE)
3 TGT TYPE TO ACQUIRE (TT AND AIS, TT ONLY)*
4 AZ STABILIZATION (STAB HDG, STAB NORTH)
5 AZ POLYGON (OFF, STAB GND, STAB HDG, STAB
NORTH, AROUND CHECK AREA*
6 CHECK AREA SETTING (PORT, STBD, BOW, STERN;
2 TRIAL MANEUVER (OFF, STATIC, DYNAMIC)
3 TRIAL SPEED RATE (0kn to 99kn, 0.00kn/s to 9.99kn/s)
4 TRIAL TURN RATE (0kn to 99kn, 0.00kn/s to 9.99kn/s)
5 TRIAL TARGET DATA (ACTUAL, TRIAL)*
APPENDIX 1 MENU TREE
1
STAB NORTH)
2 CURSOR BEARING (REL, TRUE)
3 CURSOR RANGE (NM, km, SM, kyd)
4 CURSOR SIZE (SMALL, LARGE)
5 CURSOR L/L ALIGN (OFF, ON)
STAB NORTH)
0.0NM to 16.0NM, 1.0NM)*
3
1
1
)
1
AP-3