12How To Set The Barge Marker - Furuno FAR-2218-BB Operator's Manual

1. OPERATIONAL OVERVIEW
1.42.12 How to set the barge marker
You can mark the locations of barges on the display with icons.
Note: This function is not available if [ECDIS] is set to [SERIAL] or [LAN] at installa-
tion. Consult your dealer for details.
Set up barge information as follows:
1. Open the menu.
2. Select [2 MARKS].
3. Select [6 BARGE MARK].
4. Select [2 BARGE MARK DISPLAY].
5. Select [ON] to display barge marks, [OFF] to hide barge marks, as appropriate,
then press the ENTER MARK key.
6. Select [3 BARGE SIZE]. Spin the scrollwheel to enter the [LENGTH] and [WIDTH]
of the barge.
7. Select [4 BARGE ARRANGEMENT]. This item lets you set a single barge or a
barge chain. Spin the scrollwheel to select a value, then left click to move the cur-
sor to the next line. Select number of barges (max. 9) to display. As you spin the
scrollwheel the squares light or extinguish and the number of barges selected ap-
pears at the right side.
You can also use the number keys on the Control Unit to select the number of
barges.
8. Close the menu. The barge mark is now displayed as shown in the example figure
on the previous page.
1.42.13 Antenna mark
When [2 OWN SHIP MARK] in the [2 MARKS] menu is set to [SCALED], the antenna
location is shown as a blue cross. The location of the antenna, and therefore the an-
tenna mark, is set at installation.
1-76
First row of barge [ARRANGEMENT] is displayed
as the right side of the barge icon on-screen.
X
Own ship icon
4
9
9
9
4