How To Erase A Drop Mark; Anchor Watch - Furuno FAR-3210 Operator's Manual

2. RADAR, CHART RADAR OPERATION
2.34.4

How to erase a drop mark

Erase drop mark from menu
1. Open the menu then select the [5 MAP•MARK] and [1 MARK SETTING] menus.
2. Select [7 DROP MARK] (B type) or [6 DROP MARK] (IMO and A types).
3. Select [ON] or [OFF].
4. Close the menu.
Erase drop mark by trackball
Right-click the applicable Drop mark box to show the context-sensitive menu then se-
lect [Drop1 Off] (or [Drop2 Off]). The drop mark and its data are erased.
2.35

Anchor Watch

The anchor watch is used to monitor if the ship is staying at anchor. If your vessel trav-
els more than the distance set here, the Alert 495 "Anchor Watch Error" appears in the
[Alert] box and the audio alarm sounds.
How to activate anchor watch
1. Open the menu then select [8 INITIAL SETTING] and [4
ALERT] menus.
2. Select [2 ANCHOR WATCH].
3. Select [ON]. Use the scrollwheel to set the alarm radius
(0.01 to 9.99 NM).
4. Close the menu.
2-54
Alarm
setting
Your ship's position, where
you start the anchor watch.
: Alarm triggered
0.01NM