Table of Contents
Advertisement
User's Manual of IMG-120T
3.3.3 Remote IP-based Telnet Interface
The Industrial Modbus Gateway offers management features that allow users to manage the Industrial Modbus
Gateway from anywhere on the network through remote IP-based telnet interface. After you set up your IP
address for the Industrial Modbus Gateway, you can access the Industrial Modbus Gateway's telnet interface
applications directly in your PC by entering the IP address of the Industrial Modbus Gateway under command
prompt.
Figure 3-6: Telnet Management Diagram
3.3.4 Login the Industrial Modbus Gateway Telnet Interface
The following shows how to start up the Telnet Management of the Industrial Modbus Gateway. Note the
Industrial Modbus Gateway is configured through an Ethernet connection. Please make sure the manager PC
must be set to the same IP subnet address.
For example, the default IP address of the Industrial Modbus Gateway is 192.168.0.100, then the manager PC
should be set to 192.168.0.x (where x is a number between 1 and 254, except 100) and the default subnet mask
is 255.255.255.0.
Logging in to the Industrail Modbus Gateway
1. Access Command Prompt and enter
telnet 192.168.0.100
to access the Telnet interface.
2. When the following dialog box appears, please enter the default user name and password "admin". The
login screen in Figure 3-7 appears.
Default Username: admin
Default Password: admin
Figure 3-7: Telnet Login Screen
After entering the username and password, the telnet main screen appears as Figure 3-8 shows.
-21-
Advertisement
Table of Contents
