Function Group Function Blocks - Endress+Hauser Proline Promag 55 Operating Manual

7 Block BASIC FUNCTION
42
7.1.2

Function group FUNCTION BLOCKS

⇒
BASIC FUNCTION G
BASIC FUNCTION
BLOCK SELECTION Use this function to select a function block whose value and status is shown in the
(6220) subsequent functions.
Options:
ANALOG INPUT 1
ANALOG INPUT 2
ANALOG INPUT 3
ANALOG INPUT 4
ANALOG INPUT 5
PID
Factory setting:
ANALOG INPUT 1
OUT VALUE Use this function to display the output value OUT, incl. unit and status, of the Analog
(6221) Input or PID function block selected in the BLOCK SELECTION function (6220).
PID_IN VALUE
!
(6222)
This function is not available unless the PID selection was selected in the
BLOCK SELECTION (6220) function.
User interface:
Use this function to display the controlled variable IN, incl. unit and status, of the PID
function block.
CASCADE_IN
!
(6223)
This function is not available unless the PID selection was selected in the
BLOCK SELECTION (6220) function.
User interface:
Display of an analog set value, incl. units and status, taken over from an external function
block.
SETPOINT VALUE
!
(6224)
• This function is not available unless the PID selection was selected in the
• If the service code is used to call this function, this value can be edited.
User interface:
Use this function to display the internal set value, incl. unit and status, for the PID
function block.
Device Functions Proline Promag 55 FOUNDATION Fieldbus
FOUNDATION FIELDBUS GGA
Function description
→
FOUNDATION FIELDBUS
Note!
Note!
Note!
BLOCK SELECTION (6220) function.
⇒
CONFIGURATION
⇓
FUNCTION BLOCKS
→
FUNCTION BLOCKS
Endress+Hauser
620
622