Function Group Additional Configuration - Endress+Hauser Proline Promag 55 Operating Manual

Device Functions Proline Promag 55 FOUNDATION Fieldbus
Endress+Hauser
3.2.2

Function group ADDITIONAL CONFIGURATION

MEASURED
⇒
A
VARIABLES
MEASURED VARIABLES
UNIT DENSITY Use this function to select the unit for displaying the fluid density.
(0420)
The unit you select here is also valid for:
• Fluid density entry
Options:
Metric → g/cm
SG 15 °C, SG 20 °C; g/l
US → lb/ft
lb/bbl (filling tanks)
Imperial → lb/gal; lb/bbl (beer); lb/bbl (petrochemicals)
Factory setting:
kg/l (SI units: not for USA and Canada)
g/cc (US units: only for USA and Canada)
SD = Specific Density, SG = Specific Gravity
The specific density is the ratio of fluid density to water density
(at water temperature = 4, 15, 20 °C).
UNIT LENGTH Use this function to select the unit for displaying the length of the nominal diameter.
(0424)
The unit you select here is also valid for:
Nominal diameter of sensor (function NOMINAL DIAMETER (6804) on Page 51)
Options:
MILLIMETER
INCH
Factory setting:
MILLIMETER (SI units: not for USA and Canada)
INCH (US units: only for USA and Canada)
MEASURING VALUES AAA
⇓
SYSTEM UNITS ACA
Function description
→ →
SYSTEM UNITS ADDITIONAL CONFIGURATION
3 3
; g/cc; kg/dm ; kg/l; kg/m
3
; lb/gal; lb/bbl (normal fluids); lb/bbl (beer); lb/bbl (petrochemicals);
3 Block MEASURED VARIABLES
⇒
CONFIGURATION
⇓
ADDITIONAL CONF.
3
; SD 4 °C, SD 15 °C, SD 20 °C; SG 4 °C,
040
042
13