Group System Units; Function Group Configuration; Function Group - Endress+Hauser Proline Promag 55 Operating Manual

Device Functions Proline Promag 55 FOUNDATION Fieldbus
Endress+Hauser
3.2

Group SYSTEM UNITS

3.2.1

Function group CONFIGURATION

MEASURED
⇒
A
VARIABLES
MEASURED VARIABLES
You can select the units for measured variables in this function group.
!
Note!
The units selected here have no effect on the fieldbus. They are only used for the local display and for assigned
instrument functions.
UNIT MASS FLOW Use this function to select the unit for displaying the calculated mass flow (mass/time).
(0400) The mass flow is derived from the preset (compensated) specific fluid density and the
measured volume flow.
The unit you select here is also valid for:
• Low flow cut off
Options:
Metric:
Gram → g/s; g/min; g/h; g/day
Kilogram → kg/s; kg/min; kg/h; kg/day
Metric ton → t/s; t/min; t/h; t/day
US:
Ounce → oz/s; oz/min; oz/h; oz/day
Pound → lb/s; lb/min; lb/h; lb/day
Ton → ton/s; ton/min; ton/h; ton/day
Factory setting:
Nominal diameter and country dependent → Page 123 ff.
UNIT MASS Use this function to select the unit for displaying the calculated mass. The mass is derived
(0401) from the preset (compensated) specific fluid density and the measured volume.
Options:
Metric → g; kg; t
US → oz; lb; ton
Factory setting:
Nominal diameter and country dependent → Page 123 ff.
!
The unit for the totalizers is independent of your choice here.
The unit for each totalizer is selected separately for the totalizer in question.
MEASURING VALUES AAA
⇓
SYSTEM UNITS ACA
Function description
→ →
SYSTEM UNITS
Note!
3 Block MEASURED VARIABLES
⇒
CONFIGURATION
CONFIGURATION
040
11