Endress+Hauser Proline Promag 55 Operating Manual page 92

3 Transducer Block
92
Write access with
Parameter operating mode
(MODE_BLK)
Sys. - AUTO - OOS
Troubleshooting
Sys. - read only
Operation Time
Sys. - read only
Time Since Reset
Device functions Proline Promag 55 FOUNDATION Fieldbus
"Diagnosis" Transducer Block/base index 1600
Use this parameter to rectify errors occurring in the EEPROM. The
EEPROM is split into a number of blocks. The error is rectified by selecting
the block in question and acknowledging.
"
Caution!
When eliminating faults in a block, the parameters of the block selected
are also reset to the factory setting.
Options:
CANCEL
MEASURING VALUES
SYSTEM UNITS
DENSITY PARAMETERS
QUICK SETUP
USER INTERFACE
TOTALIZER
COMMUNICATION
PROCESSPARAMETER
SYSTEM PARAMETER
SENSOR DATA
BATCH FUNCTION
ADVANCED DIAGNOSIS
AMPLIFIER PARAMETERS
SUPERVISION
VERSION-INFO
SERVICE & ANALYSIS
PRODUCTION INFO
FILTER PARAMETER
Factory setting:
CANCEL
Use this function to view the total operating time since the flowmeter was
commissioned (in seconds).
This parameter is only used in the event of a service call.
Description
Endress+Hauser