Endress+Hauser Proline Promag 55 Operating Manual page 106

3 Transducer Block
106
Write access with
Parameter operating mode
(MODE_BLK)
Info Line Mux - AUTO - OOS
100%-Value
Info Line Mux - AUTO - OOS
Format
Device functions Proline Promag 55 FOUNDATION Fieldbus
"Display" Transducer Block/base index 1800:
!
Note!
The entry is not active unless one of the following was selected in the
parameter "Info Line Mux - Assign" ( → Page 105):
• MASS FLOW IN %
• VOLUME FLOW IN %
• MASS FLOW BARGRAPH IN %
• VOLUME FLOW BARGRAPH IN %
Use this parameter to define the flow value to be shown on the display as
the 100% value.
User input:
5-digit floating-point number
Factory setting:
Nominal diameter and country dependent → Page 123 ff.
!
Note!
The unit is taken from the corresponding system unit ("System Unit -
Volume Flow" or "System Unit - Mass Flow").
!
Note!
The option is not active unless a number was selected in the parameter
"Info Line Mux - Assign" ( → Page 105).
Use this parameter to define the maximum number of places after the
decimal point for the second value displayed in the information line.
Options:
XXXXX. - XXXX.X - XXX.XX - XX.XXX -X.XXXX
Factory setting:
X.XXXX
!
Note!
• Note that this setting only affects the reading as it appears on the
display, it has no influence on the accuracy of the system's calculations.
• The places after the decimal point as computed by the measuring device
cannot always be displayed, depending on this setting and the
engineering unit. In these instances an arrow appears on the display
between the measured value and the engineering unit (e.g.
1.2 → kg/h), indicating that the measuring system is computing with
more decimal places than can be shown on the display.
Description
Endress+Hauser