Endress+Hauser Proline Promag 55 Operating Manual page 99

Device functions Proline Promag 55 FOUNDATION Fieldbus
Endress+Hauser
Write access with
Parameter operating mode
(MODE_BLK)
Main Line Mux - AUTO - OOS
Format
1 = Main line
2 = Additional line
3 = Information line
Add. Line - AUTO - OOS
Assign
"Display" Transducer Block/base index 1800:
Use this parameter to define the maximum number of places after the
decimal point displayed for the reading in the main line.
Options:
XXXXX. - XXXX.X - XXX.XX - XX.XXX -X.XXXX
Factory setting:
X.XXXX
!
Note!
• Note that this setting only affects the reading as it appears on the
display, it has no influence on the accuracy of the system's calculations.
• The places after the decimal point as computed by the measuring device
cannot always be displayed, depending on this setting and the
engineering unit. In these instances an arrow appears on the display
between the measured value and the engineering unit (e.g.
1.2 → kg/h), indicating that the measuring system is computing with
more decimal places than can be shown on the display.
Esc
+
-
Use this parameter to define the display value assigned to the additional
line (the middle line of the local display) during normal measuring
operation.
Options:
OFF
VOLUME FLOW
MASS FLOW
VOLUME FLOW IN %
MASS FLOW IN %
VOLUME FLOW BARGRAPH IN %
MASS FLOW BARGRAPH IN %
FLOW VELOCITY
TOTALIZER (1 to 3)
AI1 - OUT VALUE
AI2 - OUT VALUE
AI3 - OUT VALUE
AI4 - OUT VALUE
AI5 - OUT VALUE
PID - IN VALUE (controlled variable)
PID - CAS IN VALUE (external set point)
PID - OUT VALUE (manipulated variable)
DEVICE PD-TAG (tag name)
Factory setting:
TOTALIZER 1
3 Transducer Block
Description
1
2
3
E
A0001253
99