Endress+Hauser Proline Promag 55 Operating Manual page 73

Device functions Proline Promag 55 FOUNDATION Fieldbus
!
Endress+Hauser
2.5 Parameters of the Resource Block
The following table shows all the Endress+Hauser-specific parameters of the Resource Block.
Note!
FOUNDATION Fieldbus parameters are described in the "FOUNDATION Fieldbus Overview"
Operating Instructions (BA013S) (available at: → www.endress.com → Download).
Write access with
Parameter operating mode
Sensor - Serial Number read only
Amp. - HW Rev.Number read only
Amp. - HW Identification read only
Amp. - SW Rev.Number read only
Amp. - SW Identification read only
Amp. - Prod.-Number read only
Amp. - SW-Rev.No. read only
T-DAT
Amp. - Language Group read only
I/O - Type read only
I/O - HW Rev.Number read only
I/O - HW Identification read only
I/O - SW Rev.Number read only
I/O - SW Identification read only
I/O - Prod.Number read only
Resource Block
(MODE_BLK)
Use this function to view the sensor serial number.
Use this parameter to view the hardware revision number of the
amplifier.
Use this parameter to view the hardware ID number of the
amplifier.
Use this function to view the software revision number of the
amplifier.
Use this parameter to view the software ID number of the amplifier.
Use this parameter to view the production number of the amplifier.
Use this function to view the software revision number of the
software used to create the content of the T-DAT.
Use this function to view the language group.
Use this function to view the I/O module type.
Use this parameter to view the hardware revision number of the
I/O module.
Use this parameter to view the hardware ID number of the
I/O module.
Use this parameter to view the software revision number of the
I/O module.
Use this parameter to view the software ID number of the
I/O module.
Use this parameter to view the production number of the
I/O module.
2 Resource Block
Description
73