Service Mode Menu - Xerox Phaser 3320 Service Manual

Service Mode Menu

The Service Mode menu consists of 3 high level menu items: Data Setup, Reports, and EDC Mode. The
following tables describe the menu selections under each high level menu item.
Data Setup
Level 2
Counter Reset
Toner Low Level
Transfer Level
Density Level
Set Machine Serial Number
Clear All Memory
Reports
Level 2
Configuration
Supplies Info
Event Log
Usage Counter
DC 612 Test Pattern
EDC Mode
Level 2 Level 3
DC131 NVM 103-Time
Read Write
105-Duty
106-Deve
107-Transfer
Xerox Internal Use Only
Description
Resets the counter of the selected component; Fuser, Pick Up Roller, Retard
Roller, or Transfer Roller.
Sets the amount of toner that activates the Toner Low alarm. Can be set
from 1 to 30%. Default is 10%.
Adjusts the transfer voltage to improve ghosting or blurred images.
Changes the density of the printed image by adjusting the bias voltage.
Sets the serial number for the machine.
When selected all user defined presets and error messages are erased.
Description
The Configuration Report shows software versions and current machine
settings.
The Supplies Information Report shows print cartridge information such as
toner remaining, and toner capacity.
The Event Log contains a listing of reported errors.
The Usage Counter Report shows usage page counts since the last service
date. It shows total counts of simplex print and duplex print.
This test prints one or all of the test patterns stored in ROM. These are used
to evaluate printer performance and operation.
Level 4 Value
040 Pick Int Dely 0 to 100
msec
050 Pick SPL Dely 0 to 100
msec
030 - MHV DC K 50 to 900
030 - DEV DC K 50 to 900
030-THV K 50 to 900
Description
Change the time interval for paper
pick-up.
Change the time interval for paper
pick-up.
Charger HV Black DC Duty.
Deve DC Black.
Transfer1 HV Black Duty.
Phaser 3320 and WorkCentre 3315/3325
Error Troubleshooting
2-11
Service Manual