Fax Communication And Configuration Warnings - Xerox Phaser 3320 Service Manual

Error Troubleshooting

Fax Communication and Configuration Warnings

Code Warning
20-100 Fax Comm Error
20-200 No Groups are
configured
20-400 Line Busy
20-410 Line Error
20-500 Memory Full
20-550 Low Memory
20-600 No Answer
20-700 Not Assigned
20-900 Retry Redial
2-50 Phaser 3320 and WorkCentre 3315/3325
Service Manual
Description
During a Fax operation a
communication error occurred.
A group was selected when only a
single location number can be
used, such as when adding
locations for a multi-dial
operation.
The remote FAX did not answer.
There is an error with Fax data
reception.
The machine cannot connect with
the remote machine, or has lost
contact because of a problem
with the phone line.
The memory is full.
The printer could not connect to
remote fax after completion of
redial up to redial counter in
system data.
The remote machine did not
answer after all the redial
attempts.
The speed dial location used has
no number assigned to it.
The printer is waiting for the
programmed interval to
automatically redial.
Solution
See page 2-51.
Try again while ensuring that a
group location is not selected
when adding locations.
Try again.
Try again. If failure persists, wait
an hour or so for the line to clear
then try again.
Either delete unnecessary
documents, retransmit after more
memory becomes available, or
split the transmission into more
than one operation.
Try again. Make sure the remote
machine is OK.
Dial the number manually with
the keypad, or assign the number.
Press Start to immediately redial,
or Stop to cancel the redial
operation.
Xerox Internal Use Only