No Power - Xerox Phaser 3320 Service Manual

No Power

When system power is turned on, all lamps on the operator panel do not come on.
Initial Actions
• Turn the printer off and then on again.
• If the problem persists continue troubleshooting.
Troubleshooting Reference Table
Applicable Parts
• LVPS, PL3.1.5, LVPS
• Main Board, PL1.0.11 Phaser 3320,
PL6.1.6 WorkCentre 3315/3325
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the connection to the wall outlet.
Is the printer connected to the outlet?
2. Check the condition of the Power Cord.
Is the Power Cord damaged?
3. Check the wall outlet.
Is the proper supply voltage present?
4. Replace the LVPS (page 4-62).
Xerox Internal Use Only
Wiring and Plug/Jack Map Reference
• Phaser 3320 HVPS, LVPS, Laser, and Fuser
• WorkCentre 3315 HVPS, LVPS, Laser Unit, and Fuser
page 7-27
• WorkCentre 3325 HVPS, LVPS, Laser Unit, and Fuser
page 7-33
Yes
Go to step 2.
Replace the Power Cord.
Go to step 4.
Complete.
Phaser 3320 and WorkCentre 3315/3325
Error Troubleshooting
on page 7-22
on
on
No
Connect to
the wall outlet.
Go to step 3.
Use a different outlet.
2-61
Service Manual