Overview; Standard Orientation Of The Printer; Preparation - Xerox Phaser 3320 Service Manual

Service Parts Disassembly

Overview

This section contains the removal procedures for field-replaceable parts listed in the Parts List. In most
cases, the replacement procedure is simply the reverse of the removal procedure. In some instances,
additional steps are necessary and are provided for replacement of the parts. For specific assemblies
and parts, refer to Chapter 9.

Standard Orientation of the Printer

When needed, printer orientation is called out in the procedure as an aid for locating the printer parts.
The following figure identifies the Front, Rear, Left, and Right sides of the printer.
Left

Preparation

Before you begin any procedure:
WARNING: Allow the Fuser to cool before using the procedure.
CAUTION: Many parts are secured by plastic tabs. Do not over flex or force these parts. Do not
over torque screws threaded into plastic.
Note: Names of parts that appear in the removal procedures may not match the names that
appear in the Parts List. For example, a part called Paper Tray in a removal procedure may appear
on the Parts List as Cassette, Assy. While using removal procedure, ignore any prerequisite
procedures for parts already removed.
1. Wear an Electrostatic Discharge wrist strap.
2. Turn Off power and disconnect the power cord from the wall outlet.
3. Disconnect all cables from the printer.
4. Remove the Print Cartridge (page 4-5).
4-2 Phaser 3320 and WorkCentre 3315/3325
Service Manual
Front
Rear
Right
s3320-252
Xerox Internal Use Only