Notations In The Disassembly Text; Fastener Types - Xerox Phaser 3320 Service Manual

Notations in the Disassembly Text

• The notation "PLX.X.X" indicates the component is listed in the Parts List.
• Arrows in an illustration show direction of movement when removing or replacing a component.
• The notation "(tap, plastic, 10 mm)" or "(metal, 6 mm)" refer to the type of screw being removed.
Note: Provides information specific to the replacement of parts or assemblies.

Fastener Types

The table lists the types of screws used to assemble the printer. The procedures provide dimensions for
screws being removed.
Screw Types Used in this Product
Type
Self-tapping, plastic
Self-tapping, plastic, with
flange
Sheet Metal, silver
Self-tapping,
hex-head,
plastic, with
flange
Sheet Metal, silver with lock
washer
CAUTION:
Use care when installing self-tapping screws in plastic. To properly start the screw in
plastic, turn the screw counter-clockwise in the hole until you feel the screw engage the threads,
then tighten as usual. Improperly aligning or over tightening the screw can result in damage to
previously tapped threads. Always use the correct type and size screw. Using the wrong screw can
damage tapped holes. Do not use excessive force to remove or install either a screw or a printer
part.
Xerox Internal Use Only
Application Shape
Plastic
Parts etc.
Plastic
Parts etc.
Sheet
Parts etc.
Metal
Parts etc Plastic
Sheet
Parts etc.
Metal
Characteristics
1. Silver colored.
2. Screw thread is coarse
Coarse compared to metal screw.
3. Screw tip is thin.
1. Silver or black colored.
2. Screw thread is coarse
compared to metal screw.
Coarse
3. Screw tip is thin.
1. Silver colored.
2. Diameter is uniform.
1. Silver colored.
2. Screw thread is coarse
compared to metal screw.
3. Screw tip is thin.
1. Silver colored.
2. Includes a toothed washer.
3. Diameter is uniform.
4. Used for grounding terminals.
Phaser 3320 and WorkCentre 3315/3325
Service Parts Disassembly
4-3
Service Manual