Moving The Printer - Xerox Phaser 3320 Service Manual

Moving the Printer

The printer, with toner installed, weighs 11.3 kg (24.9 lb.).
CAUTION: When moving the printer over long distances, remove the Print Cartridge to prevent
toner spills.
Before moving the printer, do the following:
1. Turn the printer Off and disconnect all cables.
2. Allow the printer to cool about 40 minutes.
3. Remove media from the output tray and return the Tray Extension to its non-extended position.
4. Remove the Bypass Tray, then push in the center paper guide until it stops.
5. Push in the side paper guides until they stop.
6. Place the Bypass Tray inside the printer, on Tray 1.
7. Fold up the Tray 1 Extension to cover the paper feed.
8. Lift and carry the printer as shown in the illustration.
CAUTION: Do not tilt the printer more than 10 degrees to the front or back, or left or right. Tilting
the printer more than 10 degrees may cause toner spillage.
CAUTION: Failure to properly repackage the printer for shipment can result in damage not
covered by the warranty, Service Agreement, or Total Satisfaction Guarantee.
Xerox Internal Use Only
9.9 kg
21.8 lb.
16.6 kg
36.5 lb.
Phaser 3320 and WorkCentre 3315/3325
Maintenance
s3320-272
6-5
Service Manual