Xerox Phaser 3320 Service Manual page 70

Data Setup
Level 2 Level 3
Send Level 9 to -15
DTMF Level 0 to 15
Pause Time 1 to 9
Dial Mode Tone, Pulse
Modem Speed 33.6, 28.8, 14.4,
Dial 12.0, 9.6
Error Rate 5% to 10%
Clear All Mem.
Toner Low Level 1 to 30%
Clear Counts Enter Passcode
[????]
Engine Footer On[Off]
Internal Drive Yes[No]
Format
Dial Tone On[Off]
Transfer Level Level 0, Level 1,
Level 2, Level 3
Density Level Level 0, Level 1,
Level 2, Level 3
Set Machine XXX-xxxxxx
Serial Number
Machine Test
Level 2
DC305 UI Test
Xerox Internal Use Only
Description
Sets the level of the transmission signal. Typically, the Tx level should
be under -12 dBm.
CAUTION:
environment. Never change settings arbitrarily.
This sets the value of the High level tone and low level tone at DTMF
mode. (Not dial mode)
Sets the delay time when a pause is input at auto dial.
Sets the dial method: Tone, or Pulse.
Sets the maximum modem speed. When communicating with a slower
modem, the modem speed is automatically set to the lower speed. It is
best set 33.6Kbps as default setting.
When the error rate is about to exceed the set value, the Baud rate
automatically adjusts to 2400 bps. This ensures that the error rate
remains below the set value.
This function resets the system to factory default settings. All the
information set by the user is erased.
Note: Always perform a memory clear after replacing the Main Board,
otherwise, the system may not operate properly.
Sets the amount of toner that activates the Toner Low alarm. Can be
set from 1 to 30%. Default is 10%.
Resets the counter of the selected component: Fuser, Pick Up Roller,
Retard Roller, or Transfer Roller.
This function is for monitoring the engine status. When On, the engine
footer is printed on the bottom of each printed page.
When Yes is selected, the internal drive is formatted.
Turns audio monitor On/Off.
Adjusts the transfer voltage to improve ghosting or blurred images.
Changes the density of the printed image by adjusting the bias
voltage.
Sets the serial number of the machine.
Level 3 Description
Press any key to Performs a test on the LCD.
start LCD test
The Send Level is set at the best condition for the factory
Phaser 3320 and WorkCentre 3315/3325
Error Troubleshooting
2-17
Service Manual