Local Upgrade - Xerox Phaser 3320 Service Manual
Hide thumbs
Also See for Phaser 3320:
- Specifications (4 pages) ,
- Installation manual (2 pages) ,
- Service manual (67 pages)
Table of Contents
Advertisement
Maintenance
10. Select install Software. The firmware file is transmitted to the printer. The printer automatically
initializes after the upgrade is complete.
11. Check the firmware version level to confirm the upgrade was successful.
12. After the upgrade is complete, uncheck the Firmware Upgrade Enable box to maintain printer
security.
Note:
Disable Firmware Upgrades to secure the printer following the upgrade procedure.
Local Upgrade
The firmware upgrade is initiated at the Control Panel from a USB Flash drive installed in the Flash
drive port. Use this procedure to upgrade system firmware through the USB port.
1.
Load the firmware onto the USB Flash drive.
2.
Install the USB Flash drive in the Flash drive port on the printer.
3.
Select Print from USB on the Control Panel.
4.
Select the firmware file from the list displayed on the Control Panel.
5.
Select Add. The firmware file is added to the print list.
6.
Select done. The print list is dsplayed.
7.
Select the firmware file to be downloaded to the printer, then press OK to start the download.
Upgrade progress is displayed on the Control Panel. The printer reboots after the firmware is
downloaded.
8.
Check the firmware version level to confirm the upgrade was successful.
6-8
Phaser 3320 and WorkCentre 3315/3325
Service Manual
Xerox Internal Use Only
Advertisement
Table of Contents
Troubleshooting
