Tray 1 Empty
The paper has run out in Tray 1.
Applicable Error
•
07-110: Tray 1 Empty
Initial Actions
•
Load paper in Tray 1.
•
If problem persists use the following procedure.
Troubleshooting Reference Table
Applicable Parts
• Paper Empty Sensor, PL3.1.18
• Main Board, PL1.0.11 (Phaser 3320),
PL6.1.6 (WorkCentre 3315/3325)
Troubleshooting Procedure Table
Step
Actions and Questions
1.
Check that the Paper Empty Sensor
(page 4-81) and Paper Empty Actuator are
installed correctly.
Does the error persist?
2.
Replace the Paper Empty Sensor
(page 4-81).
Does the error persist?
3.
Replace the Main Board (page 4-55).
Xerox Internal Use Only
Wiring and Plug/Jack Map Reference
•
Phaser 3320 System Wiring
•
WorkCentre 3315 System Wiring
•
WorkCentre 3325 System Wiring
Yes
Go to step 2.
Go to step 3.
Complete.
Phaser 3320 and WorkCentre 3315/3325
Error Troubleshooting
on page 7-20
on page 7-25
on page 7-31
No
Complete.
Complete.
Service Manual
2-37