Comtrol ROCKETLINX ES8508 User Manual page 156

Configuration Using the Command Line Interface (CLI)
This table provides detailed information about the CLI command lines for network redundancy.
GLobal (STP, RSTP, and MSTP)
Enable
Switch(config)# spanning-tree enable
Disable
Switch(config)# spanning-tree disable
Switch(config)# spanning-tree mode
rst
stp
mst
Switch(config)# spanning-tree mode
Switch(config)# spanning-tree mode mst
Spanning-Tree Mode change to be MSTP (802.1s)
Mode
Switch(config)# spanning-tree mode stp
Spanning-Tree Mode change to be STP(802.1d) .
Switch(config)# spanning-tree mode rst
Spanning-Tree Mode change to be RSTP(802.1w) .
Switch(config)# spanning-tree mode mst
Spanning-Tree Mode change to be MSTP(802.1s).
Switch(config)# spanning-tree priority
Bridge Priority
<0-61440>
Switch(config)# spanning-tree priority 4096
Switch(config)# spanning-tree bridge-times (forward Delay) (max-age)
(Hello Time)
Bridge Times
Switch(config)# spanning-tree bridge-times 15 20 2
This command allows you configure all the timing in one time.
Switch(config)# spanning-tree forward-time
Forward Delay
<4-30>
Switch(config)# spanning-tree forward-time 15
Switch(config)# spanning-tree max-age
Max Age
<6-40>
Switch(config)# spanning-tree max-age 20
Switch(config)# spanning-tree hello-time
Hello Time
<1-10>
Switch(config)# spanning-tree hello-time 2
156 - Network Redundancy (CLI)
the rapid spanning-tree protocol (802.1w)
the spanning-tree prtotcol (802.1d)
the multiple spanning-tree protocol (802.1s)
the value of bridge priority in multiple of 4096
the value of forward delay time in seconds
the value of message maximum age time in seconds
the value of hello time in seconds
RocketLinx ES8508 Series User Guide: 2000575 Rev. A