Port Configuration (Cli) - Comtrol ROCKETLINX ES8508 User Manual

Configuration Using the Command Line Interface (CLI)

Port Configuration (CLI)

The Port Configuration group allows you to enable/disable port state, or configure port auto-negotiation,
speed, duplex, flow control, rate limit control, and port aggregation settings. It also allows you to view port
status and aggregation information.
Optionally, you can use the web user interface for configuration, see
This table provides detailed information about the CLI commands for port configuration.
Port Control
Switch(config-if)# shutdown
Port1 Link Change to DOWN
interface fastethernet1 is shutdown now.
Port Control
Switch(config-if)# no shutdown
– State
Port1 Link Change to DOWN
Port1 Link Change to UP
interface fastethernet1 is up now.
Switch(config-if)# Port1 Link Change to UP
Switch(config)# interface fa1
Port Control
– Auto
Switch(config-if)# auto-negotiation
Negotiation
Auto-negotiation of port 1 is enabled!
Switch(config-if)# speed 100
Port1 Link Change to DOWN
Port Control
set the speed mode ok!
– Force
Switch(config-if)# Port1 Link Change to UP
Speed/
Duplex
Switch(config-if)# duplex full
set the duplex mode ok!
Switch(config-if)# flowcontrol on
Flowcontrol
Port Control
– Flow
Control
Switch(config-if)# flowcontrol off
Flowcontrol
152 - Port Configuration (CLI)
on for port 1 set ok!
off for port 1 set ok!
Port Configuration
-> Disable port state
-> Enable port state
RocketLinx ES8508 Series User Guide: 2000575 Rev. A
on Page 70.