Table of Contents
Advertisement
Port Status
Switch# show interface fa1
Interface fastethernet1
Administrative Status : Enable
Operating Status : Connected
Duplex : Full
Speed : 100
Flow Control :off
Default Port VLAN ID: 1
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Status
Port Security : Disabled
Auto Negotiation : Disable
Loopback Mode : None
STP Status: forwarding
Default CoS Value for untagged packets is 0.
Mdix mode is Disable.
Medium mode is Copper.
Note: Administrative Status -> Port state of the port. Operating status -> Current status of the
port. Duplex -> Duplex mode of the port. Speed -> Speed mode of the port. Flow control -
> Flow Control status of the port.
Rate Control
Switch(config-if)# rate-limit
egress
Rate Control
– Ingress or
ingress
Egress
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.
Switch(config-if)# rate-limit ingress mode
all
broadcast
Rate Control
– Filter
flooded-unicast
Packet Type
multicast
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Switch(config-if)# rate-limit ingress bandwidth
Rate Control
<0-100>
– Bandwidth
Switch(config-if)# rate-limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
RocketLinx ES8508 Series User Guide: 2000575 Rev. A
Outgoing packets
Incoming packets
Limit all frames
Limit Broadcast frames
Limit Broadcast, Multicast and flooded unicast frames
Limit Broadcast and Multicast frames
Limit in megabits per second (0 is no limit)
Configuration Using the Command Line Interface (CLI)
Port Configuration (CLI) - 153
Advertisement
Table of Contents
