Comtrol ROCKETLINX ES8508 User Manual page 184

Configuration Using the Command Line Interface (CLI)
MAC Address Table (continued)
Switch# show mac-address-table static
Show MAC
Destination Address
Address Table
-------------------
– Static MAC
00c0.4e3A.0101
addresses
00c0.4e3A.0102
Switch# show mac-address-table aging-time
Show Aging
timeout time
the mac-address-table aging-time is 300 sec
Port Statistics
Switch# show rmon statistics fa4 (select interface)
Interface fastethernet4 is enable connected, which has
Inbound:
Outbound:
Port Statistics
Number of frames received and transmitted with a length of:
Switch(config)# mirror en
Enable Port
Mirror
Mirror set enable ok.
Switch(config)# mirror disable
Disable Port
Mirror
Mirror set disable ok.
Switch(config)# mirror source fa1-2
both
rx
Select Source
tx
Port
Switch(config)# mirror source fa1-2 both
Mirror source fa1-2 both set ok.
Note: Select source port list and TX/RX/Both mode.
Select
Switch(config)# mirror destination fa6
Destination
Mirror destination fa6 set ok
Port
184 - Monitor and Diag (CLI)
Address Type
--------------- -------
Static
Static
Good Octets: 178792, Bad Octets: 0
Unicast: 598, Broadcast: 1764, Multicast: 160
Pause: 0, Undersize: 0, Fragments: 0
Oversize: 0, Jabbers: 0, Discards: 0
Filtered: 0, RxError: 0, FCSError: 0
Good Octets: 330500
Unicast: 602, Broadcast: 1, Multicast: 2261
Pause: 0, Deferred: 0, Collisions: 0
SingleCollision: 0, MultipleCollision: 0
ExcessiveCollision: 0, LateCollision: 0
Filtered: 0, FCSError: 0
64: 2388, 65to127: 142, 128to255: 11
256to511: 64, 512to1023: 10, 1024toMaxSize: 42
Received and transmitted traffic
Received traffic
Transmitted traffic
Vlan Destination Port
-------------------
1 fa4
1 fa5
.
RocketLinx ES8508 Series User Guide: 2000575 Rev. A