Warnings (Cli) - Comtrol ROCKETLINX ES8508 User Manual

Configuration Using the Command Line Interface (CLI)

Warnings (CLI)

The ES8508 provides several types of warning features for you to remotely monitor the status of the attached
devices or changes in your network. The features include Fault Relay, System Log and SMTP Email Alert.
Optionally, you can use the web user interface for configuration, see
This table provides detailed information about the command lines of the warning configuration.
Fault Relay Output
Relay Output
DI State
Dry Output
Event Selection
Example:
Cold Start event
Example:
Link Up event
180 - Warnings (CLI)
Switch(config)# relay 1
di DI State
dry dry output
ping ping failure
port port link failure
power power failure
Note:
ring super ring failure
Switch(config)# relay 1 di
1 DI number
Switch(config)# relay 1 di 1
high high is abnormal
low low is abnormal
Switch(config)# relay 1 di 1 high
Switch(config)# relay 1 dry
<0-65535> turn on period in second
Switch(config)# relay 1 dry 5
<0-65535> turn off period in second
Switch(config)# relay 1 dry 5 5
Switch(config)# warning-event
coldstart
warmstart
linkdown
linkup
authentication
di
fault-relay
loop-protect
power
ring Switch ring event
time-sync
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Switch(config)# warning-event linkup
[IFNAME] Interface list, ex: fa1,fa3-5
Switch(config)# warning-event linkup fa1
Set fa5 link up event enable ok.
Warning
Switch cold start event
Switch warm start event
Switch link down event
Switch link up event
Authentication failure event
Switch di event
Switch fault relay event
Switch loop protection event
Switch power failure event
Switch time synchronize event
RocketLinx ES8508 Series User Guide: 2000575 Rev. A
on Page 116.