Using Portvision Dx (Telnet Or Ssh) - Comtrol ROCKETLINX ES8508 User Manual

Configuration Using the Command Line Interface (CLI)

Using PortVision DX (Telnet or SSH)

You can use PortVision DX to access the CLI using the following procedure.
1. If you have not done so, install PortVision DX
2. Start PortVision DX.
3. Right-click the ES8508 in the Device List pane (lower) and click Telnet/SSH.
4. Select either Telnet or SSH and leave the default port number.
134 - Using PortVision DX (Telnet or SSH)
(Installing PortVision DX
RocketLinx ES8508 Series User Guide: 2000575 Rev. A
on Page 19).