Sony MVS-8000X User Manual page 319

1
2
3
4
318
Snapshot Operations in the Flexi Pad Control Block
In the M/E-1 bank, make the settings for the state you want to save as a
snapshot.
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This assigns the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the register
number last recalled on the bank.
Use any of the following methods to select the bank for saving the
snapshot.
(On a simple type Flexi Pad control block, there are no banks, and this
operation is not necessary.)
To select bank 0: Press the [BANK 0] button.
To select bank 1: Press the [BANK 1] button.
To select any bank from 0 to 9: Press the [BANK SEL] button, changing
the memory recall section display as in the following figure; select a
number from 0 to 9.
The selected bank number appears in the numeric display.
The buttons in the memory recall section change to show the names of the
registers in the selected bank, together with the register status.
Using the Setup menu, it is possible to specify which to display, the
register name or register number.
Lit orange: register containing a snapshot
Lit yellow: last recalled register
Not lit: register not containing anything
To apply an attribute, hold down the [SNAPSHOT] button, and in the
memory recall section, press a button as follows, turning it on.
Attribute to apply
Effect dissolve
Auto transition
Button
[EFF DISS] button
[AUTO TRANS] button