Sony MVS-8000X User Manual page 321

4
Deleting a snapshot in the Flexi Pad control block (standard type
or simple type)
As an example, to delete a snapshot on the M/E-1 bank, use the following
procedure.
1
2
320
Snapshot Operations in the Flexi Pad Control Block
Control block Temporary
attribute to apply
Cross-point control A/B bus cross-point
block hold
Key cross-point hold [XPT HOLD] button in the key bus
Key disable
Flexi Pad control Effect dissolve
block
Auto transition
a) When Xpt Hold mode is selected in setup.
b) When Key Disable mode is selected in setup.
For details of the operation mode of the [XPT HOLD] button, see
"Selecting the Bank to Make the Settings" in Chapter 20 (Volume 3).
For details of temporary attributes and available attributes, see "Snapshot
Attributes" (page 309).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
Press the button in the memory recall section which shows the desired
register name.
The button you pressed lights yellow, and this recalls the snapshot.
The numeric display shows the selected register number after the bank
number.
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This assigns the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the last recalled
register number on the corresponding bank.
Select the bank for the register containing the snapshot you want to delete.
Button
[XPT HOLD] button in the
background A/B bus
[XPT HOLD] button in the key bus
[EFF DISS] button
[AUTO TRANS] button
a)
b)