Sony MVS-8000X User Manual page 347

5
6
7
8
9
10
11
12
To change the contents of a shotbox register
After recalling the shotbox register you want to change, referring to the
previous item "Creating a shotbox register," change the contents of the
shotbox register, and save.
346
Shotbox Register Creation
Notes
Only in [SHOTBOX] operation mode with the [STORE] button lit, the
[SNAPSHOT] button or [EFF] button lights green to indicate that a setting
operation is in progress for the purpose of saving snapshot data or effect
data in a shotbox register.
Press the region button for the snapshot you want to save, turning it on.
Enter the desired shotbox register number with the numeric keypad
buttons.
To find an empty register, instead of entering a number, press the [.]
(period) button.
The display shows the relevant register numbers. When a register number
is postfixed with an "E," the register is empty.
Press [ENTER].
This saves the region you turned on in step 5, and the register number you
recalled for that region as a snapshot setting in a shotbox register, and the
[STORE] button goes off. At the same time, the [RCALL] button lights.
In the numeric keypad control block, press the [EFF] button, turning it on.
Specify the register number of the keyframe effect you want to save in a
shotbox register, and then recall it for each region.
For details of the procedure for recalling a register, see "Recalling a
Register" (page 248).
Referring to steps 3 to 5, carry out the setting operation for effect register
saving. In step 4, however, press the [EFF] button, lighting it green.
Enter the shotbox register number specified in step 6 using the numeric
keypad buttons.
Press the [ENTER] button.
This saves the effect setting in a shotbox register, and the [STORE] button
goes off. At the same time, the [RCALL] button lights.