Sony MVS-8000X User Manual page 416

1
Recall the macro register you want to assign to the button. (1 to 250)
For details of recall, see page 370.
2
Press the button to which [MCRO ONLY SET] is assigned, turning it on.
3
Hold down the cross-point control block [PRE MCRO] button or [POST
MCRO] button, and press the desired button in the background A row.
The cross-point button you pressed flashes green, and the register you
recalled in step 1 is assigned to the button. The [MCRO ONLY SET]
button goes off.
Without switching to macro only mode in step 2, if you hold down the
[PRE MCRO] and [POST MCRO] buttons together and press the desired
button, it is possible to set a macro attachment in macro only mode for that
button.
To check macro attachment settings
Hold down the [PRE MCRO] button or [POST MCRO] button. While it is held
down, buttons for which macro attachments are set flash as follows.
While the [PRE MCRO] button is held down:
• Buttons set in pre macro mode: flash amber
• Buttons set in macro only mode: flash green
While the [POST MCRO] button is held down:
• Buttons set in post macro mode: flash amber
• Buttons set in macro only mode: flash green
Setting a macro attachment to a fader lever
You can set a macro attachment to any particular position of a fader lever in the
transition control block.
Notes
• In macro only mode it is not possible to set a macro attachment.
• It is not possible to set a macro attachment to a fader lever in the keyframe
control block or downstream key control block.
• For a split fader, you can set a macro attachment to the main split fader.
For details of split faders, see Chapter 3, "Split Fader" (Volume 1).
1
Recall the macro register that you want to assign to the fader lever. (1 to
250)
For details of recall see page 370.
2
Move the fader lever to the position where you want to set the macro
attachment.
Macro Attachment Assigning
415