Sony MVS-8000X User Manual page 328

The first pressed button lights green as the reference region, and
subsequently pressed buttons light yellow.
Pressing one of the amber-lit buttons, while holding down [SNAPSHOT],
turns the button green to indicate its corresponding region as the new
reference region.
For details of the precedence order for becoming the reference region, see
"Reference region" (page 227).
The display shows the name of the reference region and the number of the
register previously recalled for that region.
3
Select the bank for recall.
See step 3 (page 323) in "Saving a snapshot in the Multifunction Flexi Pad
control block."
4
To add a temporary attribute, press the [EDIT ENBL] button to switch to
editing mode, then press the [TEMP ATTR] button; you can now select the
temporary attribute with the following buttons.
[EFF DISS] button: Effect dissolve.
[DUR xxx] button: Effect dissolve duration. The current setting is shown
by "xxx."
[AUTO TRNS] button: Auto transition.
[XHLD xxx] button: Bus cross-point hold. The affected bus is shown by
"xxx."
For details of the operation mode of the [XPT HOLD] button, see
"Selecting the Bank to Make the Settings" in Chapter 20 (Volume 3).
For details of the temporary attribute and which attributes can be used,
see "Snapshot Attributes" (page 309).
Notes
Adding a temporary attribute does not affect the attribute settings saved in
registers.
To add a temporary attribute with the cross-point control block buttons,
press the following buttons, turning them on.
Temporary attribute to be
added
A/B bus cross-point hold
Key cross-point hold
Key disable
a) When setup setting is Xpt Hold mode
Button to press
[XPT HOLD] button in background A/B bus
Key bus [XPT HOLD] button
Key bus [XPT HOLD] button
Snapshot Operations in the Multifunction Flexi Pad Control Block
a)
b)
327