Sony MVS-8000X User Manual page 37

3
4
5
6
Outputting graphics to the monitor output connector
In the Graphic menu, press [Monitor Out] to turn it on.
Graphics are displayed on the device connected to the monitor output
connector.
36
Three-Dimensional Transformation Operations
Turn [Graphic] on.
The system enters graphics display mode, enabling graphics to be
displayed in the monitor screen.
Turn on the buttons of the graphics you want to show.
To show axes: Turn [Axis] on.
To show axis names: Turn [Axis Name] on.
To show the channel ID: Turn [Ch ID] on.
To show a wire frame: Turn [Wire Frame] on.
To show the grid: Turn [Grid] on.
To show the flex shadow axis: Turn [Flex Shadow Axis] on.
The selected graphics appear in the monitor screen.
Notes
The flex shadow axis function is not supported on the MVE-8000A.
If you want to shrink the graphics display to show the range not displayed
on a normal monitor, turn [Scale] on and set the following parameters.
Knob Parameter
1 Scale
As the value of the setting grows, the monitor shrinks further toward the
center point.
To automatically erase the graphic display while the keyframes are
executing, press [Auto Erase], turning it on, and then set the following
parameter.
Knob Parameter
1 Recover Time
Adjustment
Degree to which the graphics
display is shrunk
Adjustment
Time until graphic display
appears again after keyframe
execution
Setting values
0.00 to 100.00
Setting values
0 to 300 (frames)