Sony MVS-8000X User Manual page 329

5
To cancel a snapshot recall operation
After recalling a snapshot, to cancel the recall, press the [UNDO] button.
To enter the number of the register to be recalled using the
numeric keypad
After step 1 above, press the [10 KEY] button in the memory recall section.
This switches the memory recall section to the numeric keypad input mode,
and after pressing the [RCLL] button, lighting it yellow, you can enter the
desired register number from the numeric keypad. Confirm the displayed
number by pressing the [ENTR] button.
Deleting a snapshot in the Multifunction Flexi Pad control block
As an example, to delete a snapshot on the M/E-1 bank, use the following
procedure.
1
2
3
328
Snapshot Operations in the Multifunction Flexi Pad Control Block
b) When setup setting is Key Disable mode
Notes
This setting is maintained until the next time the [XPT HOLD] button is
pressed.
Press the button in the memory recall section which shows the desired
register name.
The button you pressed lights yellow, and this recalls the snapshot.
The numeric display shows the selected register number after the bank
number.
In the Multifunction Flexi Pad control block, press the [SNAPSHOT]
button, press region selection button to select [M/E1] only.
This assigns the Multifunction Flexi Pad control block to snapshot
operations. The numeric display shows the last selected bank number and
the last recalled register number on the corresponding bank.
Select the bank for the register containing the snapshot you want to delete.
See step 3 (page 323) in "Saving a snapshot in the Multifunction Flexi Pad
control block."
Hold down the [DEL] button, then hold down the button in the memory
recall section displaying the number of the corresponding register.
The button you pressed goes off, and this deletes the snapshot.