Sony MVS-8000X User Manual page 293

6
7
Checking the regions saved on a master timeline
For example in the course of changing a master timeline, you can check which
regions are saved in the register. With the [MASTR] button in the numeric
keypad control block lit, hold down the [STORE] button. While it is held down,
the buttons for the saved regions light. When the button is released, the state
before it was held down is restored.
Creating and Saving a Master Timeline Using the
Buttons in the Multifunction Flexi Pad Control Block
Creating and saving a master timeline
1
2
3
4
5
292
Creating and Saving a Master Timeline
The display shows the register number last used for master timeline
operation.
Press the [STORE] button, turning it on.
With the numeric keypad buttons, enter the number of the register (here
"1") in which you want to save the master timeline, and press the [ENTER]
button.
This saves M/E-1 register 10 and P/P register 5 in master timeline register
1, and the [STORE] button goes off. At the same time, the [RCALL]
button lights.
Press the [EFF] button, turning it on.
This assigns the memory recall section to keyframe effect operations.
Recall the register number of the effect you want to save on the master
timeline for each region. (See "Recalling a register from the numeric
keypad control block" (page 248).)
Of the region selection buttons, press those buttons for the regions you
want to save on the master timeline, turning them on.
Press the region selection button [MSTR], turning it on.
The display shows the number of the register last used for master timeline
register operation.
Press the [EDIT ENBL] button.