Creating A Shotbox Register Using The Menus - Sony MVS-8000X User Manual

This saves the snapshot data, followed by the keyframe effect data, in the
specified shotbox register, and the [STOR] button goes off and then the
[RCLL] button lights up.
To change the contents of a shotbox register
After recalling the shotbox register you want to change, referring to the
previous item "Creating a shotbox register in the Multifunction Flexi Pad
control block," change the contents of the shotbox register, and save.
To check the region saved in a shotbox register
When changing the contents or so for a shotbox register, to check the region
saved in the register press and hold the following buttons.
To check the snapshot region: [SNAPSHOT] button
To check the keyframe effect region: [EFF] button
The memory recall section buttons change as shown in the following
illustration, and the region for the saved data lights.
To recall an assigned effect and simultaneously execute it
Press the [AUTO RUN] button, lighting it green, then save the region data in
the register.

Creating a Shotbox Register Using the Menus

Accessing the Shotbox menu
Carry out creation and editing of shotbox registers in the Shotbox menu.
To access the Shotbox menu, use either of the following methods.
• In the menu control block, press the top menu selection button [SHOTBOX].
• In the numeric keypad control block, press the [SHOTBOX] button twice in
rapid succession.
Shotbox Register Creation
349