Siemens SIPROTEC 7SJ62 Manual page 418

Mounting and Commissioning
3.1 Mounting and Connections
Pickup Voltages of BI6 to BI7
Table 3-18
Binary Input
BI6
BI7
1)
Factory settings for devices with power supply voltages of 24 VDC to 125 VDC
2)
Factory settings for devices with power supply voltages of 110 to 250 VDC and 115 VAC or 115 to 230 VAC
3)
Use only with pickup voltages 220 or 250 VDC
Jumpers X71, X72 and X73 on the input/output board C-I/O-11 are used to set the bus address and must not
be changed. The following table lists the jumper presettings.
Mounting location:
with housing size
with housing size
with housing size
Bus Address
Table 3-19
Jumper
X71
X72
X73
418
Jumper settings for Pickup Voltages of the binary inputs BI6 and BI7 on the input/output board
C-I/O-11
Jumper
X21
X22
1
/ Serial no. 2 in Figure 3-4, slot 19
3
1
/ Serial no. 2 in Figure 3-5, slot 33
2
1
/ Serial no. 2 in Figure 3-6, slot 33 on right side
1
Jumper Settings of Bus Addresses of Input/Output Board C–I/O-11 for 7SJ64
Presetting
1-2 (H)
1-2 (H)
2-3 (L)
1)
19 VDC Pickup 88 VDC Pickup
L
L
C53000-G1140-C207-2, Release date 01.2008
2)
176 VDC Pickup
M H
M H
SIPROTEC, 7SJ62/64, Manual
3)