Setting Notes - Siemens SIPROTEC 7SJ62 Manual

Multi-functional protective relay with local control

Hide thumbs Also See for SIPROTEC 7SJ62:

Table of Contents

2.23 Auxiliary Functions

Figure 2-140

The following types of messages can be retrieved and displayed with the Web Monitor.

• Operational messages (buffer: event log),

• Fault messages (buffer: trip log),

• Ground fault messages,

• Spontaneous messages.

You can print these lists with the „Print event buffer" button.

2.23.10.5 Setting Notes

The parameters for the Web Monitor can be set separately via the device menu (Setup/Options/IP Configura-

tion) or via DIGSI for the front operator interface and for the rear service interface. These are IP addresses

related to the interface via which communication with the PC and the Web monitor is to be performed.

The IP addresses apply to SIPROTEC for the following operations via the

• front operator interface: 192.168.1.1

• rear service interface: 192.168.2.1

If the device has an EN100 module, operation via the system interface is also possible. In this case, the IP

address is automatically drawn from the system or individually assigned via the station configurator.

Ensure that the 12-digit IP address valid for the browser is set correctly via DIGSI or the device display in the

format ***.***.***.***.

Phasor diagram of the primary measured values - example

SIPROTEC, 7SJ62/64, Manual

C53000-G1140-C207-2, Release date 01.2008