Settings - Siemens SIPROTEC 7SJ62 Manual

Further Information
The following instruction should be noted:
• As the power factor does not differentiate between capacitive and inductive, the sign of the reactive power
may be used with CFC-help as an additional criterion.
2.17.3

Settings

Addresses which have an appended "A" can only be changed with DIGSI, under "Display Additional Settings".
The table indicates region-specific default settings. Column C (configuration) indicates the corresponding sec-
ondary nominal current of the current transformer.
Addr. Parameter
0 FLEXIBLE FUNC.
0 OPERRAT. MODE
0 MEAS. QUANTITY
0 MEAS. METHOD
0 PICKUP WITH
0 CURRENT
0 VOLTAGE
SIPROTEC, 7SJ62/64, Manual
C53000-G1140-C207-2, Release date 01.2008
C Setting Options
OFF
ON
Alarm Only
3-phase
1-phase
no reference
Please select
Current
Voltage
P forward
P reverse
Q forward
Q reverse
Power factor
Frequency
df/dt rising
df/dt falling
Binary Input
Fundamental
True RMS
Positive seq.
Negative seq.
Zero sequence
Ratio I2/I1
Exceeding
Dropping below
Ia
Ib
Ic
In
In sensitive
In2
Please select
Va-n
Vb-n
Vc-n
Va-b
Vb-c
Vc-a
Vn
2.17 Flexible Protection Functions
Default Setting
OFF Flexible Function
3-phase Mode of Operation
Please select Selection of Measured
Quantity
Fundamental Selection of Measurement
Method
Exceeding Pickup with
Ia Current
Please select Voltage
Functions
Comments
293