CH1 BPF Pass band edge frequency (High)
Medium speed
Low speed
Set a pass band edge frequency at the high frequency side for the band pass filter.
For details on the digital filters, refer to the following.
Page 31 Digital filter
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH BPF Pass band edge frequency (High)
■Setting range
For the setting range, refer to the following.
Page 33 How to use the digital filters
If a value out of the range is set, a band pass filter setting range error (error code: 198H) occurs.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
CH1 Attenuation band width
Medium speed
Low speed
Specify the attenuation band width for each digital filter.
For details on the digital filters, refer to the following.
Page 31 Digital filter
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Attenuation band width
■Setting range
For the setting range, refer to the following.
Page 33 How to use the digital filters
If a value out of the range is set, any of a low pass filter setting range error (error code: 196H), high pass filter setting range
error (error code: 197H), or band pass filter setting range error (error code: 198H) occurs.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
CH1
CH2
566
766
CH1
CH2
568
768
CH3
CH4
966
1166
CH3
CH4
968
1168
APPX
Appendix 3 Buffer Memory Areas
A
235