Mitsubishi Electric MELSEC iQ-R User Manual page 198

Interrupt factor reset request [n]
High speed
Set whether to send the interrupt factor reset request.
Setting value
0
1
When Reset request (1) is set in 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) corresponding to the interrupt factor,
the interrupt factor of the specified interrupt is reset. After that, 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) turns
to No reset request (0). When the set value is two or larger, the setting is regarded as Reset request (1).
Turning on and off 'Operating condition setting request' (Y9) also resets interrupt factors.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor reset request [n]
■Default value
The default value is No reset request (0) for all areas.
Interrupt factor generation setting [n]
High speed
Set whether to send an interrupt request when the same interrupt factor occurs during the interrupt factor detection.
Setting value
0
1
• If a value other than the above is set, an interrupt factor generation setting range error (error code: 180H) occurs.
• When an interrupt factor generation setting range error (error code: 180H) occurs in the normal mode (high speed: 1s/
CH), the A/D conversion stops in all channels.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is Interrupt resend request (0) and the same interrupt
factor occurs while the interrupt factor has been detected, an interrupt request is sent to the CPU module again.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is No interrupt resend request (1) and the same
interrupt factor occurs while the interrupt factor has been detected, an interrupt request is not sent to the CPU module. To
send an interrupt request to the CPU module, do it after setting Reset request (1) in 'Interrupt factor reset request [n]'
(Un\G156 to Un\G171) and resetting the interrupt factor.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor generation
setting [n]
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Interrupt resend request (0) for all areas.
APPX
196
Appendix 3 Buffer Memory Areas
Simultaneous
Low speed
conversion
1 2 3 4
156 157 158 159
Simultaneous
Low speed
conversion
1 2 3 4
200 201 202 203
Synchronization
Setting details
No reset request
Reset request
5 6 7 8 9
160 161 162 163 164
Synchronization
Setting details
Interrupt resend request
No interrupt resend request
5 6 7 8 9
204 205 206 207 208
10 11 12 13 14
165 166 167 168 169
10 11 12 13 14
209 210 211 212 213
15 16
170 171
15 16
214 215