Mitsubishi Electric MELSEC iQ-R User Manual page 173

Offset/gain setting mode status flag
Medium speed Low speed
■Device number
The following shows the device number of this input signal.
Signal name
Offset/gain setting mode status flag
■In the offset/gain setting mode
When registering the value, which has been adjusted with the offset/gain setting, use 'Offset/gain setting mode status flag'
(XA) as an interlock condition to turn on and off 'User range write request' (YA).
When the offset/gain setting is configured from the offset/gain setting window of an engineering tool, the setting is performed
properly on the window. Therefore, a program is not required to perform the setting.
'Module READY' (X0)
'Offset/gain setting mode status flag'
(XA)
'User range write request' (YA)
Performed by the A/D converter module.
Performed by a program.
■In the normal mode (medium speed: 10s/CH) and normal mode (low speed: 20s/CH)
In the user range setting restoration, use 'Offset/gain setting mode status flag' (XA) as an interlock condition to turn on and off
'User range write request' (YA).
For user range setting restoration, refer to the following.
Page 139 Backing up, Saving, and Restoring Offset/Gain Values
'Module READY' (X0)
'Offset/gain setting mode status flag'
(XA)
'User range write request' (YA)
Performed by the A/D converter module.
Performed by a program.
CH1
XA
OFF
ON
ON
OFF
ON
ON
CH2
ON
OFF
OFF
ON
OFF
OFF
CH3 CH4
APPX
Appendix 2 I/O Signals
A
171