Mitsubishi Electric MELSEC iQ-R User Manual page 236

CH1 HPF Pass band edge frequency
Medium speed
Set a pass band edge frequency for the high pass filter.
For details on the digital filters, refer to the following.
Page 31 Digital filter
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH HPF Pass band edge frequency
■Setting range
For the setting range, refer to the following.
Page 33 How to use the digital filters
If a value out of the range is set, a high pass filter setting range error (error code: 197H) occurs.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
CH1 BPF Pass band edge frequency (Low)
Medium speed
Set a pass band edge frequency at the low frequency side for the band pass filter.
For details on the digital filters, refer to the following.
Page 31 Digital filter
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH BPF Pass band edge frequency (Low)
■Setting range
For the setting range, refer to the following.
Page 33 How to use the digital filters
If a value out of the range is set, a band pass filter setting range error (error code: 198H) occurs.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
APPX
234
Appendix 3 Buffer Memory Areas
Low speed
Low speed
CH1 CH2
562 762
CH1 CH2
564 764
CH3 CH4
962 1162
CH3 CH4
964 1164