Mitsubishi Electric MELSEC iQ-R User Manual page 199

Condition target setting [n]
High speed Low speed
Set an interrupt factor to be detected.
Setting value Setting details
0 Disable
1 Error flag (XF)
2 Warning output flag (Process alarm)
3 Warning output flag (Rate alarm)
4 Input signal error detection flag
5 A/D conversion completed
6 Logging hold flag
7 Logging read
8 Continuous logging data storage
• When a value out of the setting range for each operation mode is set, a condition target setting range error (error code:
181H) occurs.
• When an input signal (X) or a buffer memory area set in 'Condition target setting [n]' (Un\G232 to Un\G247) turns on, an
interrupt request is sent to the CPU module. However, when A/D conversion completed (5) is set, turning on 'A/D
conversion completed flag' (Un\G42) sends an interrupt request to the CPU module.
• The same combination of the settings in 'Condition target setting [n]' (Un\G232 to Un\G247) and 'Condition target channel
setting [n]' (Un\G264 to Un\G279) cannot be used for multiple interrupt settings (1 to 16). If the same setting combination is
used for two or more interrupt settings, an interrupt condition setting overlap error (error code: 183H) occurs. Note that
setting All channels (0) in 'Condition target channel setting [n]' (Un\G264 to Un\G279) is regarded the same as setting CH1
(1), CH2 (2), CH3 (3), or CH4 (4) in 'Condition target channel setting [n]' (Un\G264 to Un\G279). Thus, the condition target
where all channels are specified cannot be used for multiple interrupt settings.
• When a condition target setting range error (error code: 181H) or an interrupt condition setting overlap error (error code:
183H) occurs in the normal mode (high speed: 1s/CH), the A/D conversion stops in all channels.
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name 1
Condition target setting [n] 232
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (0) for all areas.
Simultaneous
Synchronization
conversion
2 3 4 5 6
233 234 235 236 237
Available operation mode
High speed
Low speed
Simultaneous
conversion
Synchronization
Low speed
Synchronization
High speed
Simultaneous
conversion
7 8 9 10 11
238 239 240 241 242
Appendix 3 Buffer Memory Areas
12 13 14 15 16
243 244 245 246 247
APPX
197
A