Mitsubishi Electric MELSEC iQ-R User Manual page 232

CH1 Level trigger condition setting
Low speed
Set the condition for the occurrence of a hold trigger when using the level trigger in the normal logging function.
For details on the normal logging function, refer to the following.
Page 71 Normal Logging Function
To use the level trigger, set Level trigger condition setting to one of the following values except Disable (0).
Setting value
0
1
2
3
4
5
6
If a value other than the above is set, a level trigger condition setting range error (error code: 1D5H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Level trigger condition setting
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (0) for all channels.
APPX
230
Appendix 3 Buffer Memory Areas
Setting details
Disable
Level trigger (Rise)
Level trigger (Fall)
Level trigger (Rise and fall)
Process alarm (upper limit warning)
Process alarm (lower limit warning)
Process alarm (upper limit warning/lower limit warning)
CH1 CH2
542 742
CH3 CH4
942 1142