Gpib Communication; Usb Communication; Tilt Foot Adjustment; Rack Mounting - Newport LDC-3706 Series User Manual

GPIB Communication

The IEEE 488 GPIB interface connector is located on the rear panel, directly above the power input
module (See Figure 1.2 on page 2). Attach the GPIB cable to the 24-pin connector located on the
rear panel. The connector is tapered to ensure proper orientation. Finger-tighten the two screws on
the GPIB cable connector.
A total of 15 devices can be connected together on the same GPIB interface bus. The cables have
single male/female connectors on each end so that several cables can be stacked. This allows more
than one cable to be attached to any one device. However, the maximum length of the GPIB cables
must not exceed 20 meters (65 feet) total, or 2 meters (6.5 feet) per device. As good practice, the
number of GPIB cables connected to one instrument should be limited to less than 6.

USB Communication

The USB connector is located on the back rear panel, next to the GPIB connector. This USB
connector is the square "B"-style connector. A standard USB A/B cable is required to communicate
with the instrument. To communicate with the instrument using USB, please install the USB Driver
found on the accompanying USB Flash Drive or from the ILX Lightwave website prior to connecting
the unit to the PC. Please refer to Chapter 3 for more detailed instructions on operating the
instrument through USB.

Tilt Foot Adjustment

The LDC-3706 Laser Controller has front legs that extend to make it easier to view the display. To
use them, rotate the legs downward until they lock into position.

Rack Mounting

The LDC-3706 Laser Controller may be rack mounted by installing the appropriate rack mount flange
on either side of the enclosure. All rack mount accessory kits contain detailed mounting instructions.
Refer to the Options and Accessories table in Chapter 1 for applicable rack mount accessory part
numbers.
December 2019 13 LDC-3706 Series Laser Controller