Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface Or Subinterface - HP 6600 Configuration Manual

Step
7. Assign the port an
aggregation priority.
8. Set the LACP timeout interval
on the port to the short timeout
interval (1 second).

Configuring an aggregate interface

Most of the configurations that can be performed on Layer 2 or Layer 3 Ethernet interfaces can also be
performed on Layer 2 or Layer 3 aggregate interfaces.
Configuring the description of an aggregate interface or
subinterface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface or subinterface:
Step
1. Enter system view.
2. Enter aggregate
interface view.
3. Configure the
description of the
aggregate interface
or subinterface.
Command
link-aggregation port-priority
port-priority
lacp period short
Command
system-view
•
Enter Layer 2 aggregate interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate interface or
subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
description text
22
Remarks
Optional.
By default, the aggregation priority
of a port is 32768.
When the number of ports eligible
for becoming Selected ports
exceeds the maximum number of
Selected ports allowed in a
dynamic aggregation group,
changing the aggregation priority
of a port might affect the
aggregation state of ports in the
dynamic aggregation group.
Optional.
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
Remarks
N/A
Use either command.
Optional.
By default, the description of an
interface is in the format of
interface-name Interface, such as
Bridge-Aggregation1 Interface.