Configuring The Interface Behavior; Configuring A Rip Version - HP MSR Series Configuration Manual

If you configure RIP settings in interface view before enabling RIP, the settings do not take effect until RIP
is enabled. If a physical interface is attached to multiple networks, you cannot advertise these networks
in different RIP processes.
To enable RIP:
Step
1. Enter system view.
2. Enable a RIP process and
enter RIP view.
3. Enable RIP on the interface
attached to the specified
network.

Configuring the interface behavior

Step
1. Enter system view.
2. Enter RIP view.
3. Disable the specified interface
from sending routing updates
(the interfaces can still receive
updates).
4. Return to system view.
5. Enter interface view.
6. Enable the interface to receive
RIP messages.
7. Enable the interface to send
RIP messages.

Configuring a RIP version

You can configure a RIP version in RIP or interface view.
If neither global nor interface RIP version is configured, the interface sends RIPv1 broadcasts and
•
can receive the following packets: RIPv1 broadcast, RIPv1 unicast, RIPv2 broadcast, RIPv2 multicast,
and RIPv2 unicast.
• If an interface has no RIP version configured, it uses the global RIP version; otherwise it uses the RIP
version configured on it.
With RIPv1 configured, an interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts and
RIPv1 unicasts.
With RIPv2 configured, a multicast interface sends RIPv2 multicasts and can receive RIPv2 unicasts,
broadcasts, and multicasts.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
network network-address
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
silent-interface { interface-type
interface-number | all }
quit
interface interface-type
interface-number
rip input
rip output
23
Remarks
N/A
N/A
By default, RIP is disabled on
interfaces.
Remarks
N/A
N/A
Optional.
All interfaces can send routing
updates by default.
N/A
N/A
Optional.
Enabled by default.
Optional.
Enabled by default.